How to configure Citrix XenDesktop 5.6 with CloudGateway (Receiver Storefront) and NetScaler(Access Gateway Enterprise)
Introduction
This article describes how to set up an (Netscaler) Access Gateway Enterprise Edition VPX and (CloudGateway) Receiver Storefront for use with XenDesktop 5.6.
The purpose of this document is to record the configuration of the Citrix Access Gateway Enterprise Edition appliance and Receiver Storefront for use with Citrix XenDesktop 5.6.
This article only attempts to record a single configuration. However, it is expected that this environment can also act as a stepping stone for creating alternative or more advanced configurations if required.
The following are the various sections in this article:
Source
See the entire guide here. Howto configure Citrix XenDesktop 5.6 with Citrix Cloudgateway (Storefront) with NetScaler Access Gateway Enterprise
Enjoy /Poppelgaard
Trackback from your site.
Thomas Poppelgaard
| #
Hi Steve normal I install the GRID driver to device and when its workin, I disable the default VGA device.
Have you applied latest hotfix to the XS6.1 there are some crucial hotfixes to the GPU pass-through, that could crash the GRID’s, when you power on a VM with GPU pass-through.
Steve
| #
Just a quick question on your setup. We just got a system similar to yours (R720, 2xGrid K2 cards, XenServer 6.1, XenApp 6.5). The GRID K2 driver installs (320.00), but the device shows up as stopped in device manager. Did you use any special options when installing the nVidia driver? Or somehow remove the default VGA device?
Dan
| #
Hi Thomas,
Some features in your screenshots (eg create appointments and contacts) seem to be missing from the iOS version of @WorkMail that got released in April, do you know if these features are still coming in a future release? The Android client is far more functional by comparison.
Regards
Dan
Christian Eilskov
| #
You can see the DHCP options here:
http://www.wyse.com/kb and search for 21501
You can transfer a image using Wyse Device Manager(WDM), the same goes for smaller updates like new ICA client and so.
Thomas Poppelgaard
| #
Thank you Barry =)
The deep compression codec for Citrix XenDesktop HDX 3D Pro will be intergrated for Citrix XenApp in Excalibur so there is a big difference with bandwidth consumption. This means that XenApp in Excalibur will be the best platform for user density and works great over WAN with high latency as HDX 3D Pro have been known to deliver for several years. Yes i know of cases with WAN optimization, I will gather these and share them.
Best regards
Thomas